The TPMS revolution is here. Introducing i-sensor

Diagnosing existing sensors:
Contactless scan of existing sensors (TPMS audit) from the tyre side displaying; diagnostic
• sensor ID code
• tyre pressure (simple and safe pressure check)
• temperature (where applicable)
• battery status (where applicable)
• sensor operating frequency
Watch the DIAGNOSE SENSOR video HERE

Duplicating existing sensors:
Duplicate sensors either automatically or manually avoiding the requirement to reset the vehicle ECU when fitting new sensors – the ECU recognises the duplicate as if it were the original sensor.

Auto duplicate sensors in as little as 18 seconds:
Diagnoses an existing sensor and then programs an i-sensor blank to become a clone with the same ID and protocol
Fastest way to clone sensors with minimal input from the user
Watch the auto duplicate video HERE

Manual duplicate sensors in as little as 18 seconds:
Requires the user to input the required sensor ID into the i-sensor blank via the tool in either decimal or hexadecimal format allows the user to create a clone of the original, even when the sensor battery is depleted OE ID locator function onboard the tool and supplied in a printed version
Watch the MANUAL DUPLICATE video HERE

Creating completely new sensors:
Create a new sensor from an i-sensor blank in as little as 12 seconds. Applies a pre-programmed unique ID code and the required protocol to the i-sensor blank, ready to fit the fastest way to create your own sensors watch the PROGRAM BLANK SENSOR video HERE 

i-Sensor is a registered trademark of Autogem Invicta Ltd.

Other i-sensor videos:

Other i-sensor videos:

extended_i-sensor_1diagnose_sensorsauto_duplicate_3manual_duplicateupdate_the_toolturn on and settings creat_new_sensorsfitting_i-sensors